Focus on Biosecurity
Excess hair growth on udders can be a serious source of contamination of milk, and also a factor causing mastitis infections. Eliminating excess udder hair reduces significantly the amount of mud and manure accumulating on the udder. This dirt can be a significant cause of environmental mastitis. Udder Singe uses a low-temperature butane flame to burn hair away in 1-2 seconds, without causing any pain or damage to udder or teats tissue. Singing of udder hair is common practice in the northern hemisphere. The Shoof Udder Singe is supplied complete with a 600ml canister of butane gas. The wand is 75cm long with a plastic grip. The flame is controlled with an adjustable valve, to produce a ‘lazy yellow flame’ which will not burn the udder (This flame can be tested by running your hand through it). One can of gas should singe 300-400 udders.
Tailwell has only three moving parts. Of these, only one - the self-lubricating sliding-block Rotator Bearing - is subject to any wear. The reduction in moving parts has resulted in a cutting machine that draws the minimum amount of power, ensuring the maximum number of tails are cut from each charge.
Tailwell should be used on a 14-volt cordless power drill, with an operating speed of 1,200 to 1,750rpm. (Higher or lower drill speeds do not cut better, and may damage the machine, voiding any warranty.) A lightweight drill with a high quality battery is the best to use. A quality Li-ion 1.5Amh 14v drill battery should allow trimming of about 70 tails per charge, depending on conditions.
The Tailwell is simply placed through the flexible drill sleeve, and the chuck tightened firmly on the drive shaft. The drill-sleeve is then pulled back firmly onto the drill body to prevent any rotation of the machine. The bungee cord is then put around the back of the drill, and pulled firm. This part is for safety only, to prevent the Tailwell dropping off the drill if the chuck becomes loose.
If tails are not contaminated by sand, the cutters should stay sharp for more than 2,000 tails (depending on conditions). Sharpening the cutters is easily done by inexperienced users. The cutters are removed by opening the drive case. (Tools are supplied for this.) Honing paste is then applied to the cutter faces and they are ‘ground’ together by hand. This process should take only a few minutes. DVD and hard copy instructions are supplied.
Most important is regular and frequent lubrication of the cutters. Special oil is supplied in the kit. Tailwell Cutter Lubricant has been formulated specially for this purpose. It is a non-throw, non-dust-gathering light oil which will not ‘clog’ the cutters. We strongly recommend continued use of this lubricant, available from your Tailwell stockist. Lubricant should be used sparingly but frequently on the cutter tips - every 30-40 tails (or more frequently with sand contamination).
If cutting performance drops, the cutter tension should be adjusted promptly, before hair becomes trapped between them. This is achieved using the three finger-only screws at the back of the cutter head. Follow instructions supplied. Cutters must be kept correctly tensioned at all times to ensure correct cutting performance and cutter life.
Learn more about the Tailwell.
Cool Cow is a great system for control of biting flies, and also for keeping cows cool and comfortable in the dairy. You will see immediate reduction in cow fidgeting, tail swinging, and cups kicked off.
The standard Roadmat is 8m long x 5.2m wide. Longer or shorter mats can be made on request. Roadmat does not require any maintenance, and should last many years of use (depending of course on frequency).
**Plus freight for this container.
NB: This product can separate during storage. ALWAYS stir well before use. (See index for Farmhand™ whisk.)